Correct Way To Install Vinyl Siding

Siding must be cut in lengths to provide for expansion.

Correct way to install vinyl siding.

Allow a 1 4 inch gap for expansion wherever siding butts accessories. Install flashing before starting to apply the siding. Always refer to the installation guide on the particular vinyl siding that you re installing but most vinyl siding panels should overlap each other by at least an inch. Find out how woodbridge home exteriors one of the most trusted siding companies in the area installs your siding.

Homes function best when every element works in perfect harmony. Snap a level line all the way around your house and make sure it s level. But the type of nails you use and your nailing technique is extra important when you install vinyl siding on your home. Vinyl siding installation can sometimes be finicky because it has to be done the right way.

Unless already installed a water resistive barrier should be applied to the house prior to installing vinyl siding. A flat level wall surface is necessary for proper installation of vinyl siding. Vinyl siding must be nailed so expansion and contraction are not restricted. Best way to cut vinyl siding and installation.

Choose the right nails allow approximately 1 16 in. On hot days because the siding will contract when the temperature drops. Even the smallest parts like nails and screws make a difference. Refer to important notes for more information on water resistive barriers.

Remove any siding or exterior finish that isn t compatible with vinyl siding and make sure the walls are sheathed with a substrate to receive the siding. The siding must be installed over a flat surface so unless you re siding a new home or have removed the old lap siding you ll need to line the wall with sheets of rigid foam board usually 1 2. It is important to check your level every four or five courses by putting a level on the siding. Gap at all ends.

Vinyl siding installation is designed to hang loosely on the sheathing so that it can expand and contract with temperature changes. Between nail head and vinyl. It will be made of aluminum and it usually comes about 3 inches in width and 12 feet long. When installing in freezing weather below 4 c.

Otherwise it can allow water and pests to enter your home which defeats the purpose of this component. The first piece of vinyl you re going to hang is on the starter strip.